2BE Liquid ring vacuum pump
2BE
CONSTRUCTION TYPE
The 2BE liquid ring are of uncomplicated and robust construction with the following particular features:
non-polluting due to nearly isothermal compression
oil-free, as no lubrication in the working chamber
handling of nearly all gases and vapours
small quantities of entrained liquid can be handled
easy maintenance and reliable operation
low noise and nearly free from vibration
wide choice of material, therefore applicable nearly everywhere
shaft not contact with the medium
protection against cavitation as standard
incorporated dirt drain
incorporated central drain
no metallic contact of the rotating parts
The EMC 2BEare single-stage ones.
APPLICATIONof
Handling and exhausting of dry and humid gases; entrained liquid can be handled during normal duty. The pumps are applied in all fields where a pressure of 33 to 900 mbar must be created by robust vacuum pumps.
NOTE
During operation the pump must continuously be supplied with service liquid, normally water, in order to eliminate the heat resulting from the gas compression and to replenish the liquid ring, because part of the liquid is leaving the pump together with the gas. This liquid can be separated from the gas in a liquid separator (see catalogue part accessories).
It is possible to reuse the service liquid. The pumps are equipped with a device by which the contaminated service liquid can continuously be drained during operation (dirt drain), if necessary.
We are .
The operating data are applicable under the following conditions:
water vapour saturated air: 20°C
service liquid: - water: 15°C
Compression pressure 1013 mbar (atmospheric pressure) ----38V/50HZ
Material design
HT200
SS304
SS316L
Pressure range: 33 to 1013 mbar
Suction volume flow: 600to7500m³/h
在线联系供应商
Other supplier products
 |
Rotary Vane Vacuum Pump | Basic Principle The sucking and exhausting valves are usually fitted in the round pump body where there is a centrifugal rotor with three vanes ... |
 |
Fisher Control Valve | SEATLESS, HARDSEAT AND UNIT TANDEM Designed for blow-off service in boiler systems with pressures of 3206 psig FEATURES •DesignedaccordingA... |
 |
Singel-stage rotary van vacuum pump | Basic Principle The sucking and exhausting valves are usually fitted in the round pump body where there is a centrifugal rotor with three va... |
 |
china cast iron vacuum pump | 2BE CONSTRUCTION TYPE The 2BE liquid ring are of uncomplicated and robust construction with the following particular features: non-polluting due ... |
 |
MR95 series Industrial Pressure Regulators | Specificationsof This section lists the specifications for the MR95 Series regulators. Factory specification such as type, maximuminlet press... |
Same products
 |
盛辉供应商2CY 系列船用电动高压润滑油齿轮泵 | 卖方: 河北盛辉泵业 | 2CY 系列输油泵主要由齿轮、轴、泵体、安全阀、轴端密封件等组成。齿轮经过热处理，具有高硬度和高强度，与轴一起安装在可更换的轴套中，用于旋转工作。适用于输送温度低于 300℃、粘度 5&time... |
 |
工厂直销 LC 系列高粘度罗茨燃油输送泵 | 卖方: 河北盛辉泵业 | LC 高粘度油泵通常用于输送高粘度油和其他流体，包括油漆、润滑油、原油、玻璃胶等。它还可用于输送豆酱、糖浆和酵母等食品级物料。该设备具有效率高、操作简便、功耗低、自吸能力强、不吸油等特点。圣汇生... |
 |
高性能 LCB 系列高温沥青齿轮泵 | 卖方: 河北盛辉泵业 | 当您需要输送常温下无腐蚀性、无固体颗粒、不凝固的介质时，LCB系列齿轮泵是您的最佳选择，尤其适用于室外安装在高寒地区以及需要对介质进行保温处理的场合。 |
 |
2024年热销YQB系列液化石油气加气输送泵 | 卖方: 河北盛辉泵业 | YQB系列液化石油气输送泵常用于输送液化石油气、液氨、丙烯、丙烷、环氧乙烷、甲醇及各种性质类似石油的挥发性液体或石油产品，特别适用于液化石油气装卸车、加料车间、充装钢瓶等工作场所。 |
 |
OEM 卧式 SN 系列船用高压燃油三螺杆泵 | 卖方: 河北盛辉泵业 | SN系列三螺杆泵适用于输送润滑油、低润滑性液体、无腐蚀性矿物油、粘稠液体等润滑性液体介质，如润滑油、燃料油、重柴油及各种合成橡胶液等。该机结构紧凑，体积小，振动小，自吸能力强等特点。 |
