Carpet Peel & Tuft Tester
Product Details
For tufted carpets or traditional carpets, an important parameter is the retention performance of their tufts.
Poor - quality carpets may completely lose their tufts in certain situations, such as on staircases. For loop - pile carpets, well - formed loops can prevent the formation of long loops. This instrument can measure the force required to pull out a single tuft or loop from the carpet, that is, the bonding force between the carpet pile and the backing. This instrument is commonly used for testing small quantities of samples in laboratories, but it can also be applied in specific scenarios involving existing carpets or large - scale carpets.
Compliance Standards
BS 5229: 1975 (1996), ISO 4919: 1978
Test Method
The carpet sample is fixed by a steel template. Hold one end of the tuft to be tested with a pair of surgical forceps, or hook a loop with a metal hook. The surgical forceps or the metal hook is connected to a force - measuring balance, which is driven by a small electric motor to increase the pulling force at a steady rate. When the tension reaches its limit, the balance shows the required maximum tension. The maximum tension of the balance of the standard instrument is 5kg. When measuring carpets with greater tension, a balance with a capacity of 10kg can be selected. Dimensions: W430 mm, D300mm, H535 mm Power consumption: 20 W
Parameters
50 lbF, 25 kgF, 250 N
Peak memory for tensile loads
Accuracy: ± 0.3% of full scale ± digit
Safe overload: 150% accuracy
Selectable units of measurement: kg, N, or lbs
Push-button calibration
IPM – Intelligent Power Management system
Battery or AC operation
Send product request
Other supplier products
 |
Thermal cycle wet freezing testing machine | The Thermal Cycle Wet Freezing Testing Machine is designed for comprehensive environmental testing, capable of simulating extreme temperature and h... |
 |
In-situ expansion analysis system | Standard ASTM E83: Standard Test Method for Verification of Linear Displacement Measuring Systems ISO 12417-1: Mechanical Testing of Metals &ndas... |
 |
Abrasive Wear Test Apparatus | Standard ASTM G65 - 04 GB/T 3960-1983 Main Purposes The wet - type rubber wheel abrasive wear testing machine is primarily employed to assess t... |
 |
Diaper Anti-Side Leakage Performance Tester | The Diaper Anti-Side Leakage Performance Tester is designed to accurately measure the liquid loss of nonwoven materials and evaluate the anti-side ... |
 |
Liquid Sustained Combustion Tester | This product complies with "Recommendations on the Transport of Dangerous Goods - Manual of Tests and Criteria" 32.5.2 Test L.2: Sustained Combusti... |
Same products
 |
Air Permeability Tester STD- F8 | Seller: Standard International Group (HK) Limited | The Air Permeability Tester is designed to quickly and accurately measure the breathability and p... |
 |
Surface Performance Tester STD-FB4 - A | Seller: Standard International Group (HK) Limited | Introduction TheSurface Tester analyzes finger movements-particularly, strokes-performed by arti... |
 |
Compression Tester STD - FB3 - A | Seller: Standard International Group (HK) Limited | TheCompression Tester analyzes hand movements-particularly, pushing with a finger-performed by ar... |
 |
Single - Strand Bending Tester STD - FB2 - SH | Seller: Standard International Group (HK) Limited | Standards ASTM A370. ASTM A416. ISO6934.4 The Single Fiber Bending Tester makes it possible to ... |
 |
Bending Tester STD- FB2 - S | Seller: Standard International Group (HK) Limited | Compliance Standards ASTM D790 (Plastics Flexural Properties) ISO 178 (Flexural Strength of Rig... |
