Hard alloy titanium carbide guide wheel - transmission
Titanium carbide hard alloy guide wheels are key guiding components in the production of wire and tube materials. They are made by sintering high-purity titanium carbide and cobalt binder through powder metallurgy. The surface hardness can reach up to HRC88, and the wear resistance is over 50 times that of steel guide wheels. The roundness error is controlled within 0.002mm, ensuring smooth operation of the wire during high-speed drawing (up to 100m/s) and preventing jitter or deviation. In the production of stainless steel wire, using this type of guide wheel can reduce the surface roughness of the wire from Ra1.6μm to Ra0.4μm, significantly improving product quality. Compared with ceramic guide wheels, this type of guide wheel has better toughness and is less likely to break due to minor collisions, reducing the frequency of replacement. Its service life is 2 to 3 times that of ceramic guide wheels. In the production of steel cord, one set of guide wheels can produce over 1,000 tons of cord, while ceramic guide wheels can only produce 300 to 500 tons. The cost-performance advantage of the guide wheels makes them widely used in the tire industry, contributing to enhancing the wear resistance and safety of tires.
Send product request
Other supplier products
 |
High-hardness titanium carbide rods - quenched parts processing | As a key material in the high-end manufacturing field, hard alloy titanium carbide round rods have excellent corrosion resistance and are not prone... |
 |
Titanium carbide powder with excellent flowability | Titanium carbide powder is gray-black ultrafine powder with high purity, uniform particle size, high hardness, high temperature resistance, corro... |
 |
Titanium carbide hard alloy guide wheels - Factory direct supply | The installation holes of the guide wheel have high precision, and the fit clearance with the shaft can be controlled within 0.005-0.01mm, ensuring... |
 |
Nano grade titanium carbide alloy round bar | 该圆棒的生产工艺极其严谨，从碳化钛粉末纯度的控制（纯度≥99.5%）到烧结温度的精确调控（约1500℃），每一个环节都影响着最终的性能。成品尺寸稳定性极佳，在-50℃至300℃的温度变化下，热膨胀系数仅为6×10-⁶/℃，远低于金属材料，确保了精密工具在不同环境下的精度。它广... |
 |
Titanium carbide rods in stock can be cut as needed | Compared with traditional high-speed steel bars, the cutting speed achievable with titanium carbide hard alloy round bars can be increased by 3 to ... |
