SSAW Spiral Welded Pipe
SSAW spiral welded pipe is a spiral seam steel pipe
welded by automatic double wire
double side submerged arc welding process
SSAW spiral welded pipe is a spiral seam steel pipe welded by automatic double wire and double side submerged arc welding process, which is made of steel strip coils as raw material, extruded at high temperature and welded by automatic double wire and double side submerged arc welding.
SSAW spiral welded pipe includes ordinary spiral steel pipe and thick wall spiral steel pipe. The advantages of thick-walled spiral steel pipe compared with ordinary thick spiral steel pipe are: high compressive strength, high impact strength, high safety performance and longer service life. The strength of SSAW spiral welded pipe is generally higher than that of straight welded pipe. The welded pipe with larger diameter can be produced with narrow blank, and the welded pipe with different diameter of pipe can be produced with the same width of blank. The nominal diameter of SSAW spiral welded pipe is also called average outer diameter. This is due to the thin metal pipe, the outer diameter of the tube and the tube diameter is similar, so take the outer diameter of the tube and the average diameter of the pipe as the diameter of the call.
1.the welding clearance control device is used to ensure that the weld clearance meets the welding requirements, and the pipe diameter, misalignment and weld clearance are strictly controlled.
2 butt joint of strip head and tail, single wire or double wire submerged arc welding, automatic submerged arc welding after rolling steel pipe.
3. the welding seam is inspected by the continuous ultrasonic automatic wound tester on line, which ensures the nondestructive testing coverage of the helical weld. If there are defects, automatic alarm and spray marking, the production workers at any time to adjust the process parameters, timely eliminate defects.
4.Before forming, the strip is straightened, trimmed, planed, surface cleaned, transported and precurved.
5.The electric contact pressure gauge is used to control the pressure of the oil cylinder on both sides of the conveyer to ensure the smooth conveyance of strip steel.
6.after cutting into a single steel pipe, every batch of steel pipe shall carry out strict first inspection system to check the mechanical properties, chemical composition, melting condition, surface quality of steel tube and non-destructive inspection to ensure that the pipe making process is qualified. Can be formally put into production.
7.Weld seam with continuous sound wave flaw detection mark, after manual ultrasonic and X-ray review, if there is a defect, after repair, again after non-destructive testing, until the defect has been eliminated.
If you require further information or you do not see what yo need in our web,please do not hesitate to contact us. Our customer service specialists will be happy to help you.
Other supplier products
|
|
Monel Steel |
Monel Steel
bar （mm）8-300MM
Wire (mm) 0.2-8MM
Outer diameter of steel tube (mm) 3-426MM0.5-60 wall thickness
Strip (mm) thickness 0.05-... |
|
|
Cold Formed Welded Structural Hollow Sections |
OD:21-630mm
Wall thickness:3-40mm
Pipe Length: from 6 to 12 m.
Different lengths on request.
Pipe Ends: plain square-cut or bevelled ends for b... |
|
|
Seamless Alloy Steel Boiler Tubes |
Seamless Alloy Steel Boiler Tubes
OD:10-530mm
Wall thickness:1.5-70mm
A steel pipe made of a single piece of metal and having no seams on... |
|
|
Equal Tees Pipe Fittings |
Three links also known as pipe fittings or three-way pipe fittings, three-way joints, etc. Mainly used to change the direction of the fluid, used i... |
|
|
Welded Elbow Fitting |
Welding elbow fitting, it can be cut on the pipe or steel plate after welding, its specifications can be very large.The number of sections and radi... |
All supplier products
Same products
