Automotive Wires Liquid Resistance Tester
Test Standards:
Requirements for liquid resistance tests of automotive wires in ISO 6722. SAE J1128. QC/T 730. and JASOD611
Main Parameters:
Test Oils:
1. Heat - retaining and heating oils (to be provided by the user): It is recommended to use oils with high boiling points and low volatility, such as transformer oil. If the test temperature is low, water can be used.
2. Test media (to be provided by the user): Gasoline, diesel, engine oil, alcohol, power steering fluid, automatic transmission fluid, engine coolant, battery acid, etc.
Temperature: Ambient temperature ~ 250℃
Test set: Circular quartz glass oil cup: diameter 100mm X 350mm
Inner container volume: 400 X 450 X 450mm
Stirring: Motor - driven stirring
Volume (approximate): Dimensions: 800 X 560 X 850 (mm)
Material: Inner and outer stainless steel
Temperature sensor: Pt100
Weight (approximate): 100Kg
Power supply: 1 - phase AC380V 50Hz 7.5A Total power: 4KW
Qinsun Instruments Co., LTD is a professional laboratory testing instrument manufacturer in China,Have been focusing on laboratory instrument R&D more than 30 years and have rich industry experience,Based on international testing standards,We are also the instrument supplier for BV SGS laboratory,We provide one-stop solutions for lab instruments,Free Training and Turn-Key Service,Products exported all over the world,Offer 36 month warranty and are a trustworthy partner.
Send product request
Other supplier products
 |
Limiting Oxygen Index Tester | Limiting Oxygen Index Tester The oxygen index of the material refers to the minimum oxygen concentration that can maintain the combustion of the ma... |
 |
Car seat center of gravity measuring tester | Main parameters: ParameterDescription Measuring range Refers to the maximum and minimum range of the center of gravity of the seat tha... |
 |
Xenon Arc Weatherometer | IntroductionThe xenon arc lamp, which is capable of simulating the whole natural sunlight spectrum in the most consistent manner, can reproduce t... |
 |
Car seat belt fixed point test bench | Applicable standards: National mandatory standards: GB 15083-2006"Automobile seats, seat fixtures and headrests strength requirements and test me... |
 |
Automobile Wire Cross-linking Test Device | Applicable Standards: SAE J1128 - 2005 and other standards Main Parameters: 1. Test rod: Φ6mm, 300mm in length 2. Hot plate specification... |
Same products
 |
Seat Bumping and Creep Test Bench | Seller: Standard International Group (HK) Limited | This test bench is used for simulating the car seat bumping and creep situation when a car is run... |
 |
Automobile seat belt fixed point test bench | Seller: Standard International Group (HK) Limited | Applicable standards: National mandatory standards: GB 15083-2006"Automobile seats, seat fixtur... |
 |
Impact strength tester for car seat headrest | Seller: Standard International Group (HK) Limited | Applicable standards: GB 15083-2006 "Automobile seats, seat fixtures and headrest strength requi... |
 |
Impact strength tester for car seat launching headrest | Seller: Standard International Group (HK) Limited | Main parameters: Impact speed:The impact speed of the tester is usually between 25 and 30km/h, w... |
 |
Automobile Headrest Strength Tester | Seller: Standard International Group (HK) Limited | Applicable standards: GB 11550-2009"Automobile seat headrest strength requirements and test me... |
