Cable Top Ties/Side Ties
Function
Distribution ties are designed for securing conductors in the top groove of rigid insulators vertically mounted.
This specific distribution tie provides perfect resistance to mechanical strain under all types of motion including aeolian vibration, galloping and sway.
Distribution tie design takes into account a tie pad to protect the bare conductor from abrasion at the conductor insulator interface.
Tie pads are not required with jacketed conductors.
This product is manufactured with the same grade material| as the conductor to which it is applied.
Mechanical strength
Distribution ties have a slip load exceeding 3.5kN in unbalanced load conditions. This strength is usually sufficient to contain a broken conductor to a single span.
Note
The lay direction of distribution ties must be the same as that of the outer stranding of the conductor to which it is applied.
Другие товары поставщика
|
|
Metal Dome Type Splice Closure for Opgw Cable |
FUNCTIONIt eliminates or reduces the vibrations that come from the effect of laminar flow wind, and prevents damage of the hardware fittings and t... |
|
|
Metal Dome Type Splice Closure for Opgw Cable |
COMPONENTinner armor rods, outer armor rods, rubber clamp piece, cover shell, right-angle hanging loop, U-shaped hanging loop, bolt, nut, gasket e... |
|
|
Metal Dome Type Splice Closure for Opgw Cable |
Cable Margin Supporters for ADSS (AYLJ)The cable margin supporter is used for extra cables when emplacing cable connective ends, Usually, one cab... |
|
|
Metal Dome Type Splice Closure for Opgw Cable |
COMPONENTinner armor rods, outer armor rods, thimble, U-shaped hanging loop, extension loop, bolt, nut, etc.CHARACTERISTIC1. Stress is distributed... |
|
|
Metal Dome Type Splice Closure for Opgw Cable |
COMPONENTinner armor rods,middle outer outer armor rods, thimble, U-shaped hanging loop, PD hanging board, triangular conjoint board, bolt, nut, e... |
Все товары поставщика
Похожие товары
