Cable Top Ties/Side Ties
Function
Distribution ties are designed for securing conductors in the top groove of rigid insulators vertically mounted.
This specific distribution tie provides perfect resistance to mechanical strain under all types of motion including aeolian vibration, galloping and sway.
Distribution tie design takes into account a tie pad to protect the bare conductor from abrasion at the conductor insulator interface.
Tie pads are not required with jacketed conductors.
This product is manufactured with the same grade material| as the conductor to which it is applied.
Mechanical strength
Distribution ties have a slip load exceeding 3.5kN in unbalanced load conditions. This strength is usually sufficient to contain a broken conductor to a single span.
Note
The lay direction of distribution ties must be the same as that of the outer stranding of the conductor to which it is applied.
Other supplier products
|
|
Cable Margin Supporters for ADSS |
Cable Margin Supporters for ADSS (AYLJ)The cable margin supporter is used for extra cables when emplacing cable connective ends, Usually, one cab... |
|
|
Galvanized Vibration Damper for Opgw Cable |
Vibration Dampers for OPGW (4D)COMPONENTzincification hammerhead, zincification steel armor rods, aluminum alloy clamp, stainless steel bolt etc.FU... |
|
|
Metal Dome Type Splice Closure for Opgw Cable |
CONDITIONS FOR THE USAGEExcess length of fiber connecting and branch-connecting. It's fit to each structure of 12-72core cables with its diameter l... |
|
|
Overhead Line Fittings for Electric Power |
MaterialDead-ends:High-tensile galvanized steel.ApplicationSuited for the full tensioning of groundwire or staywire on transmission and distributr... |
|
|
Double Dead Ends Clamp for OPGW |
COMPONENTinner armor rods,middle outer outer armor rods, thimble, U-shaped hanging loop, PD hanging board, triangular conjoint board, bolt, nut, e... |
All supplier products
Same products
