Cable Top Ties/Side Ties
Function
Distribution ties are designed for securing conductors in the top groove of rigid insulators vertically mounted.
This specific distribution tie provides perfect resistance to mechanical strain under all types of motion including aeolian vibration, galloping and sway.
Distribution tie design takes into account a tie pad to protect the bare conductor from abrasion at the conductor insulator interface.
Tie pads are not required with jacketed conductors.
This product is manufactured with the same grade material| as the conductor to which it is applied.
Mechanical strength
Distribution ties have a slip load exceeding 3.5kN in unbalanced load conditions. This strength is usually sufficient to contain a broken conductor to a single span.
Note
The lay direction of distribution ties must be the same as that of the outer stranding of the conductor to which it is applied.
Other supplier products
|
|
Overhead Line Fittings for Electric Power |
MaterialDead-ends:High-tensile galvanized steel.ApplicationSuited for the full tensioning of groundwire or staywire on transmission and distributr... |
|
|
Metal Dome Type Splice Closure for Opgw Cable |
FUNCTIONIt fixes the down-leading or up-leading cable from the poles/towers to the poles/towers, preventing shaking, and avoiding attrition.CONDIT... |
|
|
Metal Dome Type Splice Closure for Opgw Cable |
COMPONENTinner armor rods, outer armor rods, rubber clamp piece, cover shell, right-angle hanging loop, U-shaped hanging loop, bolt, nut, gasket e... |
|
|
Metal Dome Type Splice Closure for Opgw Cable |
COMPONENTinner armor rods, outer armor rods, thimble, U-shaped hanging loop, extension loop, bolt, nut, etc.CHARACTERISTIC1. Stress is distributed... |
|
|
Cable Guy Grip Dead End |
Dead-ends are designed to hold insulated cables and bare homogeneous cables in transmission and distribution construction. Mechanical strength for ... |
供应产品
Same products
