Procedures to Debug the Die of Wood Pellet Press

• 

As its name implies, wood pellet mill is a machine used to pelletize those agricultural and forestry wastes into pellets of great value. After adjusting the pelletizing system well, you can operate the wood pellet making machine at normal. While, remember, you should open the discharging door on operating door during the working process.

Sequence for launching the parts of wood pellet mill should be dynamo first, agitator second and feeder last. When materials enter into the agitator, you should open the steam valve meanwhile. The saturated steam pressure should vary from the 0.2MPa to 0.4MPa. The steam temperature should be about 130-150 ℃.

For the water content in raw materials, it should be proper. If water content is higher than the rated, raw materials will be caked on the surface of moulding dies and block the die holes. On the contrary, if water content in raw materials is lower than the rated, softening degree of raw materials will be insufficient. As a result, the working efficiency of wood pellet mill will become poorer and poorer.

In general, before theworking process of wood pellet machine, you’d better notice the water content of raw materials. After raw materials enter into the granulating room, you should firstly notice the discharging condition of finished products and then the current changes. Under the normal discharging, if the electric current is less than the rated, you can increase the flow of raw materials and steam until the current reaches to the rated.

Leave messages on website to get thediscount of FTM wood pellet mill!

Fote Heavy Machinery:

Fote Official Email:

在线联系供应商

至: 河南富特重型机械有限公司
Your E-mail:
消息正文:


Send to other suppliers

Other supplier products

	Points Related With the Work of Straw Pellet Mill	Different from the traditional way to make pellets, straw pellet mill is regarded as the most ideal way to make pellets. Raw materials, being deliv...
	Points Related With Work of Hydraulic Cone Crusher	The matching of feeding size should be suitable. Service life of hydraulic cone crusher will be seriously influenced if materials are too coarse or...
	Texture for Making Parts of Hammer Mill Crusher	Through the study for more than several years, FTM Crusher Company chooses to make the easy-wearing parts of hammer mill crusher with high manganes...
	Newly-type Working System of Hammer Mill Crusher	Known as the NO.1 brand of hammer mill crusher, FTM Crusher Company has produced the newly-type crushing system.The key part of this newly-type cru...
	Maintenance Work for the FTM Straw Pellet Mill	As to the maintenance work for straw pellet mill, it should start from the first run of straw pellet mill. After each run, you should clean the str...

供应产品

Same products

	HSC Paper Sheeting Machine	卖方: Suzhou Paper Saw King Technology Co.,Ltd	HSC Paper Sheeting Machine Product Description HSC Paper Sheeting Machineincorporates an advanc...
	Bottom Feed Slitting Rewinder	卖方: Suzhou Paper Saw King Technology Co.,Ltd	Bottom Feed Slitting Rewinder Product Description The bottom feed slitting rewinderreceives pap...
	HX Tape Laminating Slitting Rewinder	卖方: Suzhou Paper Saw King Technology Co.,Ltd	HX Tape Laminating Slitting Rewinder Product Description The HX Tape Laminating Slitting Rewind...
	Full Servo Band Saw Paper Slitter	卖方: Suzhou Paper Saw King Technology Co.,Ltd	Full Servo Band Saw Paper Slitter Product Description The Full Servo Band Saw Paper Roll Slitte...
	Z1500 Circular Saw Paper Roll Slitter	卖方: Suzhou Paper Saw King Technology Co.,Ltd	Z1500 Circular Saw Paper Roll Slitter Main Characteristics Z1500 Circular Saw Paper Roll Slitte...