Mechanical Load Tester for pv module
Purpose:
This test is to determine the ability of the module to withstand wind , snow , static or ice loads
Technical specifications:
1、The machine table appearance dimension:L 280 × D 180 × H 195 cm
2、Test Positive load 5400Pa, reverse load :2400Pa (Pressure can setting)
3、Cycle times :free setting
4、Dynamic load test frequency:7s±3s
5、Dynamic load:1000Pa，1000tims
6、Pressure control accurate:5%
7、Pneumatic and force value feedback ways :low friction force cylinder,tensile pressure
sensor(accurate 0.1N)
8、Aluminum profile structure, platform and support frame under the suffer force situation, its not deformation (aluminum profile surface use electrophoresis to ensure no discoloration)
9、The maximum test dimension:2000mm×1000mm (can according to customer’s requirement to customized)
10、Customization test platform fixture, according to determinand install ways to do the adjust
11、Current continuity system :DC power, DC 120V/20A, real-time monitor module inner current continuity
12、Cylinder: 4 groups , in total 8 pieces
Single the maximum output > 200 kg
Telescopic stroke:150mm
13、Sucker:8 groups , in total 32 pieces
Sucker diameter:120mm
Sucker(with cylinder) space horizontal and vertical≤200mm
Sucker with upper connection joint can rotation angle≥15°
14、Operate system maturity and humanization
a、Computer control software research and development by HOTOTECH , easy operate and humanization
b、Every version software all equipped with unique version number, easy to Identification and upgrade
c、Software with Chinese and English language , can change each other
d、With real-time show pressure, deformation, test time, cycle times , current continuity etc function
e、Input target pressure value, test running after, the machine can automatic adjustable pressure
to target pressure value stability
f、Selected data save after, real-time test data and save
g、At the calibration window input the password and enter into the calibration backstage, fast
calibration machine and modify parameter set
h、Real-time draw real-time show pressure and deformation value
i、Real-time show every cylinder force value and draw force value curve
j、Enter into the history information and inquiry interface then input sample number research can inquiry this number history data report and print out
k、Report support output World, Excel, PDF , JPG etc format
l、Software with fault warning function, when machine happen above any situation after, software
will popup prompt window, machine will warning and prompt operator do the relative treatment
在线联系供应商
Other supplier products
 |
UV preconditioning testing chamber for pv module | Standard:According to IEC61215, IEC61646 standard requirement Purpose:to precondition the module with ultra-violet (UV) radiation before the therm... |
 |
Cord Anchorage pull testing Machine with IEC61215-2:2016 standard | Standard:according to IEC61215-2 standard requirement Purpose:Simulate module during the installation process , The module cord anchorages are uni... |
 |
Thermal cycle/humidity freeze environment chamber | Standard:According to IEC61215,UL1703 standard requirement Purpose: To determine the ability of the module to withstand thermal mismatch, fatigue ... |
|
|
Mechanical Load Tester for pv module | Purpose: This test is to determine the ability of the module to withstand wind , snow , static or ice loads Technical specifications: 1、The mach... |
 |
Solar panel Damp heat testing chamber with IEC 61215-2:2016 standard | Standard:According to IEC61215,UL1703 standard requirement Purpose:To determine the ability of the module to withstand the effects of long -term p... |
