Heel Fatigue Tester ISO 19956
Heel Fatigue Tester is used to determine the resistance of medium and high heels of ladies’ shoes under repeated small impacts to the heel tip.
Application:
The heel fatigue tester is used to determine the resistance of medium and high heels of ladies’ shoes under repeated small impacts to the heel tip.
Procedure：
Clamp the heel on the machine, adjust the height position and angle of the heel according to the equipment, adjust the hammer in the horizontal position, pre-set the number of impacts, start the equipment. The hammer would impact the heel with the specified energy of 0.68J, 60 cycles per minute. Continuous testing until the heel breaks or reaches the specified number of impacts, the equipment automatically stops, and the number of impacts is recorded. This test method is used to assess the resistance of the heel to the repeated impact with certain mass.
Feature：
A heel is subject to blows of specified energy, delivered by a pendulum under a specified frequency, testing continues until failure of the heel takes place or satisfactory fatigue resistance is achieved.
Parameters：
Impact Energy：0.68J / blow
Impact Frequency：60 blows /min
Adjustable Range of Base Clamp：90mm (H), 80mm (W), angle 0~180°
Counter LCD：0~999.999
Main unlt：46×46×75cm
Control box：18×21×20cm
Weight：70kg
Power Supply：1∮ AC 220V,3A
Standards:
BS-5131 4.9.
ISO 19956
SATRA TM21.
QB/T2864
在线联系供应商
Other supplier products
 |
Absorption tester ISO 9073 | Product Introduction: STD provides easy and reliable measurement of absorbance. This precision absorber uses the STD system's patented liquid inte... |
 |
Leather Seam Fatigue Tester |Seam Fatigue Tester | Textile Testing Products | Standards ISO 5402: Leather physical testing – Flex tester method for adhesion and strength analysis. SATRA TM55: Seam fatigue testing for ... |
 |
Footwear Cold Insulation Tester EN ISO 20344 / DIN 53351 | Product Introduction Shoes cold resistance testing machine is used to test finished shoes, rubber, sole, synthetic leather, plastic and other test... |
 |
Shoelace Abrasion Tester SATRA TM154 | Standards SATRA TM93、DIN-4843、QB/T2226、SATRA TM154 Principle Let shoelace cross the eyelet clamped on the fiber board, make the shoelace and eye... |
 |
Plastic Smoke Density Tester ISO 5659 | Standards: GB/T8323.2-2008: Plastics - Smoke generation - Part 2: Determination of optical density by a single-chamber test ISO 5659-1: Plastics -... |
Same products
 |
Bottle Wall and Bottom Thickness Tester | 卖方: Standard Group (Hong Kong) Limited | The wall and bottom thickness tester for bottles is a measuring instrument widely used in the pha... |
 |
Pinhole Tester / Pinhole Testing Equipment | 卖方: Standard Group (Hong Kong) Limited | The pinhole tester for aluminum foil is a device specifically used to detect micro - pinholes in ... |
 |
Cork Puncture and Chip Detection Instrument | 卖方: Standard Group (Hong Kong) Limited | The rubber stopper puncture debris detector is a device specifically used to detect the number of... |
 |
Aluminum Ointment Tube Toughness Tester | 卖方: Standard Group (Hong Kong) Limited | The ductility tester for aluminum tubes is a device specifically used to detect the ductility ind... |
 |
Vacuum leak tester / Vacuum leak instrument | 卖方: Standard Group (Hong Kong) Limited | Vacuum Decay Leak Tester specializes in the detection of leaks in ampoules, vials, injection bott... |
