Shoulder Ejector Sleeve Pins
| Material |
InnerHardness |
SurfaceHardness |
Heat Treatment |
| FDAC |
HRC38°±2° |
HV1000°±100° |
Nitrided |
| HRC52°±2° |
HRC52°±2° |
Vacuumed |
JH Ejector Sleeve ranges from straight, step, multiple step, or thin walled sleeves. Nitrided SKD61 being the most commonly used steel in ejection molding. However other materials as well as SKD61 including, but not limited to. Ejector Sleeves can be manufactured to a working hardness designed to your application. We also offer a variety of surface treatments such as Nitride, Titanium Nitride and Vacuumed to name a few. Sleeves ranging from under 10mm long to 1000mm long are available. Inside and outside diameters are ground concentric to ensure proper alignment. If you need we could reach the tolerance to 0.002mm
Other supplier products
|
|
Shoulder Ejector Sleeve Pins |
Material
InnerHardness
SurfaceHardness
Heat Treatment
FDAC
HRC38°±2°
HV1000°±100°
Nitrided
HRC5... |
|
|
Straight Ejector Sleeve Pins |
JH Ejector Sleeve ranges from straight, step, multiple step, or thin walled sleeves. Nitrided SKD61 being the most commonly used steel in ejection ... |
|
|
MateriaSpure Bushing-A Type JH025 |
Inner HardnessSurface HardnessHeat Treatment
S45CSR section HRC50°~55°Partial
HRC60°±2°HRC60°±2°Vacuumed
SKD1... |
|
|
Embedded Spring |
Characteristic description of embedded spring:Hard screws are fixed directly inside the alloyThe stainless steel screw is directly fixed inside t... |
|
|
Positioning Components-Locking Block Sets |
Material
Hardness
1.2343
HRC50°~56°
Type
Dimension
t
d4
d
I5
I4
I3
I2
I1
S1
b3
JHN09/30
5
4... |
供应产品
Same products
