Flame Durability Testing Machine, ISO 9038，burning behavior test apparatus

• 

Introduce：

When the hazardous liquid is heated to 0.5 ºC and 75 ºC, flame durability tester is used to evaluate the continuous burning time. When the subject material is heated and exposed to fire according to test conditions, this instrument can test its continuous burn time.

Model:STD-ISO 9038

Standards：

(chemical registration, evaluation, authorization, restriction)

ISO 9038: liquid continuous combustion performance test

Features:

• K- type thermocouple to measure the temperature automatically.

• Temperature controller automatic to control the temperature.

• Timer recording flame continue burning time.

• Flame can be moved to the sample position.

• Portable butane gas can be stored in the special gas tank fixture;

• Pressure device can automatically measure the current barometric pressure

• Solenoid valve to control the gas switch.

• Imported gas control valve control airflow to adjust the flame length.

Test results judge condition：

• Tobe testthree times. Required to record following points:

a) Check the ignition test sample or test position when the flame moves to its continuous combustion conditions

b) When the flame is placed in the test position to be tested, check whether the sample is ignited. If ignited, then the flame is returned to the "off" position, then start the time record for combustion duration of the test specimen

• If the sample is non-sustained combustion test is deemed passed, if it is sustained combustion type, so even if the failure. If any test sample that contains one of the following, it will be defined as a particular heating time duration of combustion.

• If the test sample from the test base of 45 degrees and it is ignited, the need to observe and record its combustion performance.

• When the test sample is ignited, and the test flame is moved from the test base 45 degrees position, if sustained burn more than 15 seconds, you need to observe and record the combustion performance.

Specification:

Other supplier products

	Limiting Oxygen Index Chamber	The Limiting Oxygen Index (LOI) fire test is perhaps the most economical and precise quality control test for combustible materials. Its ease of us...
	Metallic Cables and Wire Ropes Mechanical Property Testing Machine	Standard YY/T 0812-2010 (China): Specifies mechanical testing protocols for metal cables/cables used in fracture fixation, including fatigue stren...
	Foam Repeated Compression Tester	Foam repeated compression testing machine will accurately measure the thickness of the test piece, placed in the compression plate of the testing m...
	Helmets Designated Protection Areas Tester	Main Purposes 1. Used to mark test points and test lines on helmets. 2. Used for line - marking according to different test standards. 3. Used t...
	Closed - Space Tester for Aerosol Sprays	Product Description Conforms to UN Recommendations on the Transportation of Dangerous Goods - Manual of Tests and Criteria 31.5 Confined Space Ign...

Same products

	Large Scale Vertical Fire Resistance Test Furnace，Long-lasting fire resistance furnace for coatings	Seller: Standard International Group (HK) Limited	Description Fire resistance performance of materialprovideimportant information for evaluation s...
	Single Burning Item，test apparatus， BS EN 13823	Seller: Standard International Group (HK) Limited	Introduction Single burning instrument (SBI) was measured supplies (excluding floorings) perform...
	Room Corner Tester，Room corner fire test equipment， ISO 13784	Seller: Standard International Group (HK) Limited	Introduction According to ISO9705 of building materials fire prevention performance standards, t...
	Smoke Density Chamber， ISO 5659，Smoke density testing equipment	Seller: Standard International Group (HK) Limited	Introduction The main principle is to measure smoke density in a particular space, cable or mate...
	LIFT, IMO Spread of Flame Apparatus，ISO 5658，flame propagation tester	Seller: Standard International Group (HK) Limited