Durability Tester for Automotive Wire Markings
Test Standard:
Complies with the ISO19642 standard.
Test Method:
For the durability tester of automotive wire markings, fix a wire approximately 300mm long on the machine table with the printed part facing upward. Use a friction hammer equipped with wool felt to rub the printed part with a certain load, speed, and reciprocating stroke, so as to check the fastness of the printed part. It can also be used to test the fastness of the printed characters on the plastic surface.
Main Parameters:
| Parameter | Description |
|---|---|
| Friction speed | 10 - 40 C.P.M (adjustable as needed) |
| Friction distance | 250 mm |
| Load | 10 ± 1 N (per ISO 19642) |
| Wool felt | 50 × 50 × 3 mm (75% wool, 25% fiber) (per ISO 19642) |
| Test groups | 3 groups (simultaneous testing of 3 samples) |
| Spare parts | 15 wool felt pieces (50 × 50 × 3 mm, 75% wool, 25% fiber) |
| Counter | 6-digit (range: 0–999,999) |
| Motor | 40 W |
| Power supply | 220 V, 50 Hz |
Send product request
Other supplier products
 |
Car seat belt locking performance tester-QINSUN | Applicable standards: Automotive seat belt locking performance tester mainly meets the following national or industry standards: GB 14166-2013Sea... |
 |
Universal Wear Tester | Standards ASTM Standards: D3514, D3885, D3886 (textile, coating, and plastic wear resistance) AATCC Standards: 119, 120 (fabric abrasion and pi... |
 |
Universal Wear Tester(UWT)/Stoll Quartermaster | Application: Universal Wear Tester (UWT) is used to determines the wear and abrasion resistance of fabric used in clothing, footwear and industr... |
 |
Paper folding tester | Standards: ISO 2758、ISO 2759 ASTM D774、 D774M TAPPI T 403、TAPPI T 804 Test principle： The machine uses the motor drive screw to move the fixtu... |
 |
Sweating Thermal Manikin | Standards: ASTM F 2371 – Standard Test Method for Measuring the Heat Removal Rate of Personal Cooling Systems Using a Sweating Heated Maniki... |
Same products
 |
Seat Bumping and Creep Test Bench | Seller: Standard International Group (HK) Limited | This test bench is used for simulating the car seat bumping and creep situation when a car is run... |
 |
Automobile seat belt fixed point test bench | Seller: Standard International Group (HK) Limited | Applicable standards: National mandatory standards: GB 15083-2006"Automobile seats, seat fixtur... |
 |
Impact strength tester for car seat headrest | Seller: Standard International Group (HK) Limited | Applicable standards: GB 15083-2006 "Automobile seats, seat fixtures and headrest strength requi... |
 |
Impact strength tester for car seat launching headrest | Seller: Standard International Group (HK) Limited | Main parameters: Impact speed:The impact speed of the tester is usually between 25 and 30km/h, w... |
 |
Automobile Headrest Strength Tester | Seller: Standard International Group (HK) Limited | Applicable standards: GB 11550-2009"Automobile seat headrest strength requirements and test me... |
