AC REACTOR (OUTPUT REACTOR & INPUT REACTOR)
It is installed at the output end of the inverter to limit the capacitive charging current of the cable connecting the inverter and the motor, and to passivate the voltage rise rate of the PWM wave output by the inverter. When the motor cable length exceeds a certain value, it is recommended to insert a motor reactor between the inverter and the motor. It is used to compensate the capacitor recharging current when the wire is long. This larger length depends on the rating of the inverter and the type of motor cable.
application:
1. Limit dv/dt to 500V/us
2. Limit the overvoltage on the motor terminals to: 1000V to 400V~ (rms value)
1150V to 460V~ (rms value)
3. Filter interference caused by opening the contactor between the filter and the motor
4. Reduce motor ground leakage current
Technical specifications:
1. Working voltage: Ф3/380VAC-1140VAC
2. Working frequency: 50/60Hz.
3. Working current: 3A-1600A
4. Carrier frequency: 2-6KHz.
5. Insulation class: class F, H
6. Operating environment: -10~+45 ℃, the rated value will not be reduced. The higher temperature can reach +55℃, above 45℃, for every 1℃ increase, the rated current will decrease by 2%
7. Protection level: IP00-IP22
8. Pressure drop: <4% greater than this range will cause torque loss
9. Larger current: 1.5×rated current, continuous 60S
10. Noise: ≤65dB
11. Temperature rise: ≤85K
12. Dielectric strength: iron core-winding 3000VAC/50Hz/5mA/10s no arcing breakdown (factory test)
13. Insulation resistance: 1000VDC insulation resistance ≥100MΩ
14. The altitude does not exceed 2000 meters.
15. The operating environment temperature is -25℃～+45℃, and the relative humidity does not exceed 90%.
16. There is no harmful gas around, no flammable and explosive materials.
17. The surrounding environment should have good ventilation conditions. If installed in a cabinet, ventilation equipment should be installed.
18. Executive standard:
IEC289:1987 reactor
GB10229-88 reactor (eqvIEC289:1987)
JB9644-1999 semiconductor electric drive reactor
Other supplier products
|
|
AC REACTOR (OUTPUT REACTOR & INPUT REACTOR) |
It is installed at the output end of the inverter to limit the capacitive charging current of the cable connecting the inverter and the motor, and ... |
|
|
AC ISOLATION TRANSFORMER |
Isolation transformer refers to a transformer with electrical isolation between the input winding and the output winding. The isolation transformer... |
|
|
WAVE FILTER |
The sine wave filter is driven by PWM inverter, and its switching frequency range is between 2-8khz, which still provides sine wave output voltage.... |
供应产品
Same products
|
|
chemical equipments |
卖方: rachanashakti fabtech pvt ltd |
chemical process equipment, storage silo & platforms, Pharmaceutical equipment, Storage Tanks, Pr... |
|
|
chemical equipments |
卖方: rachanashakti fabtech pvt ltd |
chemical process equipment, storage silo & platforms, Pharmaceutical equipment, Storage Tanks, Pr... |
|
|
WAVE FILTER |
卖方: Fujian Hongyan Electrical Company Limited |
The sine wave filter is driven by PWM inverter, and its switching frequency range is between 2-8k... |
|
|
AC REACTOR (OUTPUT REACTOR & INPUT REACTOR) |
卖方: Fujian Hongyan Electrical Company Limited |
It is installed at the output end of the inverter to limit the capacitive charging current of the... |
|
|
Dry magnetic-shielding shunt reactor high voltage and medium voltage |
卖方: Shandong Taikai Power Electronic Co., Ltd. |
Connected in parallel at one winding side of substation transformers at various levels. When the ... |
