Positioning Components-Locking Block Sets
| Material | Hardness |
| 1.2343 | HRC50°~56° |
| Type | Dimension | |||||||||
| t | d4 | d | I5 | I4 | I3 | I2 | I1 | S1 | b3 | |
| JHN09/30 | 5 | 4 | M10 | 16.5 | 4.5 | 20 | 11.5 | 10.5 | 36 | 30 |
| JHN09/42 | 7 | 5 | 18.5 | 5.5 | 15.5 | 14.5 | 46 | 42 | ||
| JHN09/54 | 8 | 6 | M12 | 20.5 | 7.5 | 25 | 18.5 | 17.5 | 56 | 54 |
| JHN09/80 | 11 | 8 | M16 | 25.5 | 30 | 28.5 | 27.5 | 76 | 80 | |
Attentions given by positioning component supplier who wholesales high quality positioning component:
Remember the following points as you position multiple components:
• All the components are positioned together without any relative movement between one another.
• You can define constraints for multiple components in the same manner as you do for a single component.
• You can add one or more components for positioning even as the Position tool is active. The added component immediately gets the transformation that the other components are sharing.
• If you have selected 2 or more components for positioning, you cannot deselect any of them until they are positioned.
• You can move and reposition multiple components as one unit using the handles of the dragger. While dragging a linear handle, you can snap the components to a geometric reference and constrain them.
• If you add one or more components to a positioned multiple component set, any constraints that were applied earlier while positioning the components are cleared.
在线联系供应商
Other supplier products
 |
MateriaSpure Bushing-A Type JH025 | Inner HardnessSurface HardnessHeat Treatment S45CSR section HRC50°~55°Partial HRC60°±2°HRC60°±2°Vacuumed SKD1... |
 |
Embedded Spring | Characteristic description of embedded spring:Hard screws are fixed directly inside the alloyThe stainless steel screw is directly fixed inside t... |
 |
Straight Ejector Sleeve Pins | JH Ejector Sleeve ranges from straight, step, multiple step, or thin walled sleeves. Nitrided SKD61 being the most commonly used steel in ejection ... |
 |
Sling Ejector Pin JHN03 | Ejector pinis the “bouncer” of the injection molding world. They apply force to eject a part from the mold, and in some cases can leave... |
 |
Shoulder Ejector Sleeve Pins | Material InnerHardness SurfaceHardness Heat Treatment FDAC HRC38°±2° HV1000°±100° Nitrided HRC5... |
