Solar Radiation Meters / Solar Radiation Sensors
Product Introduction:
The purpose of this instrument is to measure the temperature change of the sample with radiant heat.
Arrange the sample and its reference material on the sample table, install it on the measuring table at an Angle of 45°, set a heating plate parallel to the measuring table, measure the surface temperature of the two samples with a radiation thermometer, etc., and measure by regression extrapolation method.
Standard:
ISO 9060:2018
ISO 9060
ISO 17025
Product Features:
Sample table or holder designed to accommodate both a test sample and a reference material of a specific size (10 cm x 7 cm).
Mounting system for the sample table positioned at a 45° angle relative to the radiant heat source. The table is likely painted black (as indicated by "black painting" for the measuring table Angle) to standardize its thermal properties.
Parallel heating plate made of aluminum black plate, serving as the controlled radiant heat source.
Heater with a controlled operating temperature (90℃) managed by PID control for stability.
Fixed spacing between the sample station (measuring table) and the heater (15cm).
Requires an external radiation thermometer or thermal imaging system (as noted in the "Attention" section) to measure the surface temperature of the samples non-contact.
Designed to operate within a controlled measuring chamber environment with specified temperature (20$pm$1℃) and relative humidity (50$pm$10%RH).
Includes calibrated components for the measuring table and heater.
Uses a regression extrapolation method for data analysis.
Includes a heater storage box.
Specification parameters:
Model: STD-IT-PT
Sample size: 10 X 7cm
Compare sample size: 10 X 7cm
Heater: Aluminum black plate
Heater operating temperature: 90℃
Heater control mode: PID control mode
Measuring table Angle: 45 degrees (black painting)
Sample station/heater spacing: 15cm
Equipment calibration: Measuring table (including sample mounting rack and sample table)
Heater (including temperature controller)
Heater storage box
Measuring chamber conditions: 20±1℃， 50± 10%RH
Power supply: AC100V or 220v (using downlink transformer)， 50hz or 60hz
在线联系供应商
Other supplier products
 |
Geotextile Dynamic Puncture Tester ISO 13433 | Scope of application: It is used to test the penetration ability of various geomaterials to resist steel cones falling from a fixed height, so as ... |
 |
Qinsun SUNTEST XLS+ | Modern desktop models, ideal instruments for 3D samples, equipped with various easy-to-use accessories, allowing SUNTEST to meet your different n... |
 |
Footwear Flexing Tester SATRA TM92 | Product Introduction: The finished shoe resistance zigzag tester drives the zigzag part of the finished shoe to zigzag repeatedly with the zigzag ... |
 |
Luggage Walked Wear Test Machine / Suitcase Walk Testing Machine | Product Introduction This product is used for suitcases, bags, strollers with wheels… Through the test mileage and test speed, to check the... |
 |
Schopper Folding Endurance Tester ISO 5626 | Use and Scope of application: 1. the instrument is suitable for tensile strength greater than 1.33kn/m, thickness less than 0.25mm paper folding d... |
Same products
 |
Bottle Wall and Bottom Thickness Tester | 卖方: Standard Group (Hong Kong) Limited | The wall and bottom thickness tester for bottles is a measuring instrument widely used in the pha... |
 |
Pinhole Tester / Pinhole Testing Equipment | 卖方: Standard Group (Hong Kong) Limited | The pinhole tester for aluminum foil is a device specifically used to detect micro - pinholes in ... |
 |
Cork Puncture and Chip Detection Instrument | 卖方: Standard Group (Hong Kong) Limited | The rubber stopper puncture debris detector is a device specifically used to detect the number of... |
 |
Aluminum Ointment Tube Toughness Tester | 卖方: Standard Group (Hong Kong) Limited | The ductility tester for aluminum tubes is a device specifically used to detect the ductility ind... |
 |
Vacuum leak tester / Vacuum leak instrument | 卖方: Standard Group (Hong Kong) Limited | Vacuum Decay Leak Tester specializes in the detection of leaks in ampoules, vials, injection bott... |
