360 rotary tank cleaning equipment, orbital tank washer
High impact 3D rotary tank washer
Working Principle:
Impeller is driven by cleaning fluid and drives internal reduction mechanism. Gear mechanism operates according to set track to realize the revolution and the rotation, thereby achieving 360° thorough cleaning.
Programmed rotation machines:The cleaning fluid drives via the turbine an internal gear reducer that keeps the sprayer turning in two planes.In the course of spraying cycle, the jets sweep the entire inside surface of the tank according to the preprogrammed, model-specific pattern.This takes a certain amount of time, but these models generate the highest jet pressures (= force of impact) and are therefore ideal for very large tanks and the toughest of cleaning tasks.
The standard machine configuration uses two or four nozzles to blast the tank walls and rinse all surfaces. In operation, the unit has to run for the cycle time between on type 8 and 12 min depending on type and pressure. This ensures full cleaning. For extremely difficult applications the cleaning time might have to be extend.
●Optimized structural design results in a water jet that produces greater impact
●Excellent sealing design, less than 3% leakage, thus saves cleaning fluid
●Independent gearbox design protects gear from damage and can work inpoor water quality
●Adopt high hardness and wear resistant materials, long service life
TApplication:
STD DG5 rotary tank washer is suitable for 3D cleaning of small to medium sized tanks,vessel or machines. It is commonly used in beer industry, petroleum, beverage,fuel ethanol, chemical, industrial fermentation,marine and where a high cleaning performance is required.
● Storage tank
● Fermentation tank
● IBC totes
● Fish vessel
● Reactors
●Process vessels
●Underground storage tanks (USTs)
●Rail cars
●Dryers, silos, towers (2d)
Send product request
Other supplier products
 |
Profilometer | Product Introduction: The profiler is measured by the slip of the stylus of the instrument and the surface to be measured, and is a contact measur... |
 |
Custom horizontal plate air-powered mixers | STDHorizontal plate mixer for small tanks STD2 For small tanks, with reducer, stainless steel horizontal plate, and special blades (for high-visco... |
 |
Rating Observation Board-QINSUN | Product Overview TheRating Observation Boardis an intelligent monitoring system designed for real-time evaluation and visualization of product qua... |
 |
Fully Automatic AC/DC High - Voltage Tester for Wires and Cables | Standards ISO 14572. IEC 60529: International standards for wire insulation integrity and environmental testing. UL 2556. CSA C22.2: North Amer... |
 |
100-V2 steam generator tester | Meet the standard: The 100-V2 steam generator meets the requirements of Ford FLTM BI 107-05. GMW15919 and FCA LP-463PB-64-01 thermal shock test sp... |
Same products
 |
Seat Bumping and Creep Test Bench | Seller: Standard International Group (HK) Limited | This test bench is used for simulating the car seat bumping and creep situation when a car is run... |
 |
Automobile seat belt fixed point test bench | Seller: Standard International Group (HK) Limited | Applicable standards: National mandatory standards: GB 15083-2006"Automobile seats, seat fixtur... |
 |
Impact strength tester for car seat headrest | Seller: Standard International Group (HK) Limited | Applicable standards: GB 15083-2006 "Automobile seats, seat fixtures and headrest strength requi... |
 |
Impact strength tester for car seat launching headrest | Seller: Standard International Group (HK) Limited | Main parameters: Impact speed:The impact speed of the tester is usually between 25 and 30km/h, w... |
 |
Automobile Headrest Strength Tester | Seller: Standard International Group (HK) Limited | Applicable standards: GB 11550-2009"Automobile seat headrest strength requirements and test me... |
