Thermal Protective Performance Tester (TPP)
The Thermal Protective Performance (TPP) Test Device was developed to measure the time elapsed for convective and radiant heat to penetrate through a protective composite fabric system - measuring the resulting damage to human skin. Standards： BS EN ISO 6942. EN 366. EN 407. ISO 11612. ASTM F1939. ASTM F2702. NFPA 1971. NFPA 2112. GB 38543. GB/T 38306 Feature： Industrial personal computer with analysis software is suitable for severe testing conditions. Automatic calculation for heat transmission factor and radiant heat transfer index. Sample holder with force applied kit is easy to operate. Single pump for shutter movement and cooling water loop. TPP Specifications： • Up to 7.5 in x 7.5 in. (19 cm x19 cm) sample size • Copper slug calorimeter sensors (ASTM or ISO) • ± 0.75°C temperature measurement • ± 3% radiant heat flux measurement • Device Dimensions: 42 in. x 20 in. x 18 in. (107 cm x 51 cm x 46 cm) • Space Requirements: 46 in. x 26 in. x 24 in. (117 cm x 67 cm x 61cm) • Power Requirements: 208-265 VAC, 50/60Hz, Single-phase • Maximum nominal current 20 Amps • Compressed Air: Clean/dry air at 70-90 PSI, (145 PSI max) • Cooling Water: Cooling water required, chiller or tap water source is acceptable • Propane Requirement: Regulated supply at 15 PSI (minimum) • Water-cooled radiant heat source with 9 quartz (500W) infrared lamps • Two gas burners with flame detection auto ignition • Mass flow controller for precise gas control • Water-cooled protective shutter • Pneumatic sample carriage and shutter assembly • Integrated sensor cooling stand (air cooled) • Emergency stop cuts gas flow, power to lamps and pneumatics • Tinted tempered glass shield protects operator • Software safety interlocks monitor water flow, carriage position, burner ignition
Другие товары поставщика
|
|
Carpet Dynamic Load Tester |
Compliance Standards
ISO 2094: 1999 (BS)
QB/T 1091-2001
ASTM D3574 TEST I4
Instrument Features
Provide information on the reduction in the t... |
|
|
Salt fog corrosion resistance tester |
Meet the standard:
GB/T2423.17
Product Introduction:
This type of salt spray test chamber is one of the artificial climate environmental “... |
|
|
Medical Face Mask Differential Pressure meter |
Medical face mask differential pressure tester also called mask breathility tester is to determine the breathability of medical face mask materials... |
|
|
Bone Screw Pull-out Tester |
Standard
YY/T 1504, ASTM F543:
standard specifies a test method for measuring the axial force required to extract or fail a metallic bone screw f... |
|
|
Minimum Ignition Energy (MIE) – Dust Cloud Tester |
Description：
Dust Cloud Minimum Ignition Energy Tester disperses a certain mass of dust specimen to be tested into the Hartmann tube device thro... |
Все товары поставщика
Похожие товары
